How to Do Plumbing for a Bathtub

To install a bathtub, follow these steps. Make sure that the bathtub has all the necessary plumbing attachments, including the faucet, water handle, drain, and strainer. Also, remember to secure the drain cover, trip lever, and linkage. Level the floor and test for levelness before securing the pipes. If necessary, use pliers to tighten the strainer. Once the strainer is tight, you can apply putty to the seam. The bathtub also includes a drain and overflow drain. Both are attached to a larger pipe under the floor, which sends wastewater to the main sewer line. To help prevent overflow, the overflow drain directs the overflow into a separate drain pipe. The one-piece surround is the easiest to install, while the others require some drilling. It’s also possible to install a one-piece surround, which will make the job easier. Before repairing the plumbing, disconnect the waste and overflow. The flange connects the tub to the studs. You’ll need a screwdriver to remove the drain pipe. Some tubs have a set screw that can be removed by turning it counterclockwise. If you’re not able to remove the spout, the flange is the support beam that holds the edge of the tub. Next, install a drain elbow. Make sure to allow enough room for the stringer. The stringer should be longer than the tub, but it must not stretch the tub’s gasket. Too much tightening could crack the tub or break the seal. If you have excess plumbers putty, remove it from the flange and use it elsewhere. You can use it again after you’re done installing the tub. Installing a bathtub may seem like a simple task, but it requires a lot of plumbing skills and strength. You should also have a lot of tools on hand to complete the job. Purchasing the right tools is an essential part of the process, but if you don’t have the proper equipment, it may end up costing you more than you’d spend hiring a plumber. If you’re not sure whether to attempt the job yourself, watch a few how-to videos and decide if you’re up to the challenge. Installing a new tub can cost anywhere from £1000 to six thoUKnd dollars. In some cases, the plumbing will be so complex that a plumber will charge upwards of £200 an hour. This may be possible in some situations if the tub is not too difficult to install, but if you’re confident with the tools you own, you can try it yourself if you want to save money. After you have completed the job, be sure to caulk the walls and connect the water line. To remove a bathtub drain, remove the strainer using a screwdriver or your fingernail. Be careful not to let any screw fall down the drain! Run water in the bathtub to check its flow. If it’s not flowing properly, you might need to push through the clog with a drain stick. To remove the strainer, make sure to follow the manufacturer’s instructions. Some drains may be easy to remove with your fingers; others may require pliers or a wrench. Click here to learn more about gas boiler installers derby.