How to Install New Shower Plumbing

Whether you want to add a new shower or replace an old one, it’s important to know how to install new shower plumbing. If you’re doing it yourself, the process may seem a bit daunting at first, but it’s actually quite easy once you have the right tools and know-how. Listed below are several simple steps to help you install a new shower. Follow these steps to make the job a little easier. Before beginning, make sure to turn off the water. To do this, you will need to open the drywall and locate the plumbing pipes. The new valve needs to fit in the same spot as the old one. You also need to check if the wall studs are damaged and fix the drainage system. Then, install the new faucet. Don’t forget to replace the old valve with the new one. Once the new valve is installed, reconnect the water pipe with the old one. Connect the pipes to the new shower. Make sure you have the correct size. You can use a wire brush to clean the inside of the adapters. Once the adapters are ready, install the mixing valve. Make sure to install the mixing valve in the proper position. It should fit into the shower drain perfectly. Make sure the valve has a water-tight seal. After completing the installation process, you should test the shower to make sure that it functions properly. Start by removing the old shower valve. Use needle-nose pliers to pry it off. Be sure to remove any retainer nuts that may be holding the old valve in place. Now, slide the new valve into place. Then, screw the column down to the stud where the showerhead will be located on the other side. Once this is done, make sure to connect the new valve to the water line below. Once you’ve removed the old shower valve, it’s time to remove the old trim plate. This flat backing will protect the shower valve from water seepage, which can lead to excessive damage in your home. To remove the trim plate, simply loosen the screws that hold the trim plate on the valve. Once the trim plate is removed, you can install the new shower valve. This step should take a few hours. You can expect to spend about two hours working on this project. Measure the height of the new shower head and the mixing valve. Then, mark the distance between the old mixing valve and the new shower head. Once you have the height, you can cut the pipes to the new height. Remember to use a copper pipe cutter to remove the old pipes. You can then thread them through the stud holes. This process should take around an hour. When it’s complete, the installation process will take only a few days. After you have measured the height of the wall tile and the depth of the old valve, you need to measure the pipe. If the old valve does not have access holes, you can use a Phillips screwdriver to unthread it. You can also use a hex-head wrench to remove the old valve. Once the copper pipe is shortened, you need to install the spout and attach the new valve. Click here to learn more about plumber in derby.