How to Use a Plumbing Auger

If you have clogged drains in your house, you might be wondering how to use a plumbing auger. This simple device works by uncoiling the snake at the end of the tool. Before feeding the snake into a pipe, keep the handle near the entrance. Once the snake is in the pipe, uncoil the cable as much as you can. As the snake feeds down the pipe, rotate the handle until the auger reaches the clog. The process is similar to opening a wine bottle. First, you must pull the toilet. It is important to keep in mind that a cleanout is a small hole in the drain pipe. Ideally, a cleanout will be nearby. If it doesn’t exist, the best solution is to call a plumber. Secondly, you can use a plumbing auger for a variety of jobs. For example, a toilet can be pulled out to gain access to the sewer line. Another common plumbing issue is a clog in the main drain. The auger will not work if it cannot reach the clog. To use the auger for this task, first locate the P-trap. This is a U-shaped section of pipe underneath a sink that leads to the wall. In such a case, you should use a plumbing auger. Using a plumbing auger can help you eliminate the clog and restore normal water flow. Before you begin using a plumbing auger, be sure to wear safety goggles and rubber gloves. Make sure to have a bucket handy to catch any water you flush into the drain. Then, insert the auger cable into the drain. Once in place, feed it down the pipe. It may take a few tries to work it through the drain. Once it reaches the drain, carefully crank the handle to make it descend. A plumbing auger is also known as a sink auger. It consists of a flexible cable with a corkscrew end attached. This cable is typically three to six feet in length and is meant to reach the waste opening. A sink auger has a smaller diameter than a toilet auger, but provides more leverage to remove plugs. The cable in a sink auger is generally coiled inside a plastic drum that has a handle. There are many different types of plumbing augers on the market. A plunger is used for smaller pipes and a plumbing auger is used for larger ones. A plumber will use a plumbing auger if the pipe is too large for a plunger. If the clog is larger than the auger head, you will need to use a mechanical one or call a plumber. However, it is possible to use a plumbing auger on small drains and not have a professional plumber come out. Manual snakes are less powerful and sturdy than electrical augers. They’re usually used for kitchen sinks and bathtubs and shower drains that are clogged. They also require turning corners and feeling for bends, and may not be able to break up stubborn clogs. These tools are not recommended for the most complicated drains. A plumber can recommend a professional or purchase a plumbing auger to get the job done right. Click here to learn more about gas boiler replacement derby.