How to Change a Plumbing Valve Safely and Correctly

If you have ever wondered how to change a plumbing valve, you’re in the right place. This article explains how to replace a valve safely and correctly. There are some things to consider before tackling this task, so you can avoid costly mistakes. Follow these steps to change the valve yourself. You’ll be glad you did! Continue reading for some handy tips and tricks. Then, enjoy the water-saving benefits of a new valve! First, you’ll need a pipe wrench. This tool is essential if you plan to change a valve on a wall. A pipe wrench helps you to unthread the old valve. Turn it counterclockwise to loosen it. Then, you’ll need to remove the old thread tape from the threads. After removing the old thread tape, you’ll need to rethread the valve and apply new thread tape. If you’re replacing a threaded valve, you’ll need a thread sealant as well. First, locate the water shutoff valve. It’s most likely in your basement or garage. Look for the label. This valve will usually be near the toilet or sink. There is a chance that it’s a soldered connection. It may also be a compression fitting or screwed on. If you can’t find the valve at home, you can visit a hardware store for one. Then, disconnect the water main shutoff from the water main. After loosening the compression nut, you’ll need to remove the old valve from the pipe. If you’re dealing with a copper pipe, you can use a grit cloth to remove any oxidized metal material. Make sure that your pipe is clean before you start cutting it. Remember to replace the compression ring as well, as a properly installed valve will prevent a leak from developing. If you’ve tried all the above methods, but the problem continues, you can try replacing the valve’s internal components. This is especially useful if you’re dealing with a massive valve, since this can cause a pipeline channel to break or leak. In this case, be sure to use a new valve of the same brand and size. Remember to keep in mind that you should avoid over-tightening the valve, or it could cause a leak. Before beginning the repair, you should ensure that you have all the necessary tools and equipment. Before starting the project, be sure to protect the surrounding area by putting a piece of tape over the copper tubing. If possible, use a soldering torch with a low flame. Place the torch near the valve body, and then pull the valve out. You may need to twist it as you go, so wear leather gloves. To change a sweat valve, you must remove the old one. Before you start replacing the valve, you should clean the exposed tubing using an emery cloth and flux. Before replacing the quarter-turn valve, you should use a flame-protective cloth. Wear gloves and safety glasses. Make sure to wear leather gloves and a flame-proof cloth to avoid a hazard. Then, install the new quarter-turn valve. Click here to learn more about derby boiler repairs.