How to Do Plumbing in Basement

If you’ve been considering installing a toilet in your basement, you’ve probably wondered how to do plumbing in basement. A toilet in the basement presents many of the same design challenges as one on a space station. In addition to not having a full-sized sink and shower, a basement toilet must also flush without the usual forces. If you want to make your basement toilet work properly, here are some steps to follow. The first step in installing a bathroom in your basement is to dig out and remove the concrete floor. You’ll need to rough in the exterior walls before tackling the plumbing and wiring. If you’re building a bathroom addition, you’ll need to take out any concrete floors in the basement first, then mark the locations of wall framing and the location of the sewer line. If you don’t have a carpentry crew, you’ll need to call a plumber to complete the plumbing and wiring. The next step is to locate the main drain. This will be a vertical pipe about four inches in diameter that runs into the basement floor. Before you start digging, you’ll need to check your local building codes. If your basement floor has an existing drainage pipe, it’s possible to find it with a metal detector. You can also dig a trench to access the drain. Then, connect the pipe to the existing drain and vent lines. Once you’ve located the sewer line, you can install a backwater valve to keep sewage from backing up into the toilet. Before you begin, make sure to contact a plumber for the required permits. Some homeowners will need to excavate the ground below their basement floor to install the necessary drainage system. In addition to a backwater valve, installing a bathroom in a basement may require you to remove a portion of the floor and excavate the ground below it. Before you start digging, make sure you’ve got the right tools for the job. You need a pipe snapper to help you cut old cast iron pipe, but a reciprocating saw is necessary for plastic pipes. You may also need a concrete saw to cut through the concrete slab at the main line. Breaking up the floor at the main line may take several whacks before it finally cracks. You may also need to cut out larger chunks of concrete. The next step is to determine where you’ll install the new bathroom. If you have a basement bathroom already, you can use the same plumbing and electric system that was in place at the upper level. If not, it’s time to break up the concrete floor to install drainage pipes. Once you have your drainage pipes in place, the walls will be installed. If you’re not sure where the walls should go, consider consulting a plumbing professional who can help you do the job correctly. Once you have chosen the type of toilet, you should consider the depth of the sewer lines. For a sink to function properly, it should have a minimum of half an inch of drop per linear foot. Adding a bathroom in the basement is relatively easy, but you’ll need to consider the plumbing depth in addition to the size of the pipes. In some homes, a deep sewer line makes it possible to install a sink. Click here to learn more about oil boiler spares derby.