How to Install Pool Plumbing

Here are some basic steps to installing pool plumbing. First, determine the type of pool you have and the size of the plumbing system. If you have a rectangular pool, a 16′ x 32′ rectangle would require approximately 7 to 8 yards of concrete with 8″ thickness. Mark the plumbing to be out of the way of the concrete. Next, secure the wall structure with a collar. String lines are used to verify that the panels are flush with the string line. Choose the type of piping you want to use. Most piping comes with couplings built into the ends. Some will need a 90 or 45-degree fitting. If not, you can easily bend the pipe gently using a blow torch. You can also purchase a kit that includes all the piping needed to run an inground pool. To avoid any leaks or breaks, be sure to purchase the correct piping. When installing the plumbing system, make sure to mark the locations of the return and the waste water lines. The return side will feed the water features and water equipment in the pool. This line is then fitted with a tee fitting and a valve to control the amount of water. You can also install a 3-way Jandy Valve for the return side. This valve will control how much water goes to each feature. The pressure side leak occurs after the pump impeller. It’s the pipe section that pushes water back into the pool. Glue and threaded joints are most likely to develop cracks on the pressure side. To patch these leaks, you can use pool putty. This will draw into the crack, but it’s a temporary fix. Eventually, a new section of pipe will need to be installed. When installing inground pool plumbing, remember that the pipes are hidden under the ground. Make sure to lay out the pipes properly so that you don’t have to dig around them. First, locate the drain. Then, attach a 90-degree elbow to the end of the coupling. Put on PVC cleaner before the PVC glue. Next, connect the two pipes together. Make sure to align the pipes to run in the same direction. When choosing the pipes, keep in mind that the size of the pipe will depend on the desired pool water flow. For example, a 2″ pipe would carry less volume than a 4″ pipe. In addition, a 4″ pipe would require about four times more pipe than a two-inch pipe. And a 90-degree elbow would add approximately 10 feet to the overall pipe run. In addition, you’ll need to know how to install pool plumbing. When assembling pool plumbing, keep the circulation system in mind. Without water, your pool won’t function properly. A dirty filter will be ineffective, and your equipment will break down. You’ll also need to ensure that the water level is the correct one. Water can decrease or increase, and either of these two situations could interfere with your plumbing. After installing pool plumbing, you should always check its water level and make any necessary adjustments. Click here to learn more about emergency plumber derby.