How to Install Shower Plumbing Step-By-Step

If you’re considering installing a new shower in your home, you’ll likely be wondering how to install the shower plumbing. This article will walk you through the process step-by-step, including mounting the valve. Ensure that all of the pipes are connected correctly before you begin. Make sure to keep leaks to a minimum. This will prevent you from having to repair your plumbing as soon as it’s installed. Listed below are some tips to help you make your project a success. Before connecting pipes, you should clean the ends of the pipe with Teflon tape and level them before screwing in the valve. Next, you need to connect the valve to the two outlets of the shower. The valve must have two inlet channels for hot and cold water and two outlet channels for the shower head and tub spout. Connect the pipes with the appropriate fittings using the male threads on the pipe. If you’re using brass fittings, make sure to solder the copper piping. Copper pipes are more likely to leak, so you’ll want to make sure that they’re securely attached to the wood blocks before screwing in the shower plumbing. Before replacing the faucet, you’ll need to cut a hole in the wall behind the shower surround. For this, you can use a jigsaw or a hacksaw with a fine blade. You can also use a drill bit to cut a hole in the plastic panel behind the faucet. You can find paintable access panels at plumbing supply stores, home centers, and online. Make sure to cut the panel to the correct size, as the jigsaw blade could hit the pipe and damage it. To install the handle, you’ll need an Allen key to attach the handle. The lever on the handle should point downward when the water is turned off. Once you have determined the correct size, the next step is to mark the height of the mixing valve. The mixing valve is located between the tub faucet and the shower head. You can use the height of the shower head as a guide to determine the proper height for the valve. If you’re unsure of the height, try estimating the height of the person who will be using the shower. Then, cut the copper pipe to the height you need. Before you start installing the shower faucet, you should turn off the main water valve in the house. The main water valve is the valve that turns on the water for the entire house. If you’re unsure of how to turn the valve, you can always call a plumber. If you have any doubts about the installation process, you can check the videos below. After you have watched them, make sure to follow the steps listed for you. To install the shower valve, you should be familiar with the installation process. For this, you should first remove the shower control handle. Next, remove the old valve and attach the new trim plate. Make sure to seal the new trim plate with plumber’s putty or caulk. Finally, install the shower valve assembly using the screws included in the kit. The diverter is the component that directs the water from the plumbing line to the shower head. Click here to learn more about local plumbers derby.