How to Remove a Push Fit Plumbing Connector

Push fit plumbing connectors are fast becoming a popular alternative to traditional pipes and fittings. While you may be able to unbolt the connector easily, removing it can be difficult. The following steps will help you remove the fitting. Before starting, ensure you have all the tools necessary. It may be a good idea to practice on a small area first. Also, make sure you wear gloves when removing the fitting. First, disconnect the water supply. The water meter is usually located on the side of the house, near the sewer line. Then, use a screwdriver or similar tool to unscrew the fitting. Make sure that the pipe is free of burrs and sharp edges. Burrs can make the connection between the pipes difficult, resulting in a leak. Next, mark the correct depth for the push fit plumbing connector. Once you’ve made the right measurement, you’ll need to mark the end of the pipe. A tape measure or a marker will make this much easier. This will ensure the perfect fit. Then, insert the push-fit fitting over the marked pipe end and push it until it stops going any further. Make sure to align the depth of the pipe before you tighten it back into place. If you do not follow the manufacturer’s instructions, there may be burrs in your pipe, which will damage the O-ring and compromise the watertight seal. To remove a push-fit fitting, you need the right tool. These tools are small plastic clips. Slide them over the pipe and press against the release collar. The pipe will come loose. Some fittings are meant to be reused, while others are designed to be used only once. Unless you are sure you can reuse the fitting, it’s better to cut fresh PEX tubing before you try to reinstall it. Installing a push-fit plumbing connector is simple, but you must prepare the pipe. Make sure that the end of the pipe is smooth and clean. You’ll also need to cut the pipe so that the fitting’s depth will match. Once the pipe is prepared, push-fit plumbing connectors provide an almost foolproof connection. If the pipe’s exterior surface is smooth and free of debris, the fitting won’t leak. To remove a push-fit plumbing connector, you can use a SharkShifter or other tool that snaps over the fitting. Then, insert a pair of tongs and pull the pipe until it snaps off. After that, you can use a disconnecting tongs to pull the pipe out. Then, slide the tongs over the fitting and use it to disconnect the pipe. Click here to learn more about boiler derby.