How to Use a Plumbing Snake to Unclog a Toilet

If you’ve been wondering how to use a plumbing snake to unblock a toilet, you’ve come to the right place. This article will provide you with a few tips to help you get started. First of all, you should always test your toilet before attempting to unclog it. If the plunger doesn’t work, you’ll want to call a plumber for help. Once you have the necessary tools, you can begin the procedure. Connect the snake to the power source and push the head down the drain pipe. Once inside the pipe, you can engage the reverse button on the snake and pull it out. When finished, flush the toilet to make sure the obstruction is gone. If you accidentally clog the pipe, the snake might get stuck. It’s important to remember that the snake can get stuck and may damage the pipes. Next, set up the plumbing snake so that it is angled toward the toilet bowl. After that, pull it back slightly. Turn it counterclockwise to release the cable and push downward pressure on the clog. Repeat the process several times until you remove the obstruction. Once you’ve unclogged your toilet, make sure that you don’t flush anything large down the toilet. If the obstruction is too stubborn to be removed, you can always try using a small auger instead of the more expensive plumbing snake. To use a plumbing snake to unclog your toilet, first check to see that the end of the snake has a curved hook that will break up debris in the pipes. Make sure the plastic coating is still intact, otherwise wrap the end with duct tape. Then, turn the crank of the toilet a couple of times. By using the snake, you should soon be able to see that your toilet is unclogged. Using a plumbing snake to unclog sluggish drains can be a pain, but it’s worth it once you know how to do it properly. By following a few simple tips, you can unclog a toilet and avoid having to call a plumber again. Then, you’ll be on your way to a drier and clearer bathroom! A plumber’s snake usually comes in a 30-foot length and puts a lot of force into a short length of pipe. You need to take your time as a 30-foot snake can get you through most of the main drain, but it will have to work its way through many turns and twists in the pipes. If you’re unable to reach the main drain using a snake, it may force itself into an adjacent fixture. If you’re unsure of how to use a plumbing snake to unblock a toilet, you can use a hanger as a clog-remover. Simply unwind the wire so it’s straight and works like a drain snake. Be sure to put a cloth around the wire before using it to prevent damage to your pipes. Once you’ve done this, the clog should be removed, but don’t forget to clean the toilet thoroughly afterwards. Click here to learn more about boiler cover chellaston derby commercial.