Plumbing How-To: Planning and Executing Your Project

One of the most frustrating parts of any plumbing project is the planning stage. Walk through the house with your blueprints, marking where vents and drainage runs will go. Visually mark each hole to make sure you do not miss any on the final walk-through. Next, determine where you’ll run pipes. Make sure they are in the center of framing members. Then, use felt or wood shims to line them. Pipes should be measured and ordered. When roughing in your plumbing, you’ll need to know the size of your pipes and the placement of fittings. You’ll want to route them near the fixtures. Also, make sure to leave at least six inches of free space around the pipes. When making cuts in the pipes, you’ll want to use a reciprocating or hacksaw. Then, use rough sandpaper to remove burrs. Once the pipe has been cleaned, you’ll need to apply PVC pipe glue to the fittings. You’ll need to hold them in place for ten or fifteen seconds. You may want to hire somaeone to advertise for you. If you’re a plumbing apprentice, you may have some existing contacts in the industry. You can’t take over the customers of your former employer, but you can entice new customers based on your reputation and experience. You’ll need to advertise to attract new customers, and a multi-pronged approach is the best way to do so. A mailing list and direct mail will allow you to reach out to potential customers and make your name known. Installing a new toilet is easier than you may think. Make sure to mark where the drain is located so you don’t accidentally cut it while you’re putting the tub in place. A high-torque drill will work best for this task. If you can’t locate the joists under the floor, you can also use a stud & joist drill. Then, you can drill the holes and attach the tub. After preparing your tools, it’s time to install the drain fittings. To install a drain, apply a generous amount of glue on the fitting, then push it into place. After that, rotate the fitting to make sure there are no bare spots inside the glue joint. When done, wipe away excess glue with a clean cloth. Then, follow the instructions carefully. You’ll be surprised at how easy and affordable it can be. You can even repair small leaks yourself! You can buy leak patch kits at any hardware store. You can also make your own patch by using heavy rubber from an inner tube and a C-clamp. Factory-made kits usually contain metal plates and a rubber pad that goes over the hole. Once you’ve completed this process, you’ll be set for a long-term repair job. And don’t forget to get a professional plumber to check out any pipes that are causing strange noises and leaks. Click here to learn more about derby heating plumber.