What Is a Compression Joint in Plumbing?

If you’re new to plumbing, you might be wondering: What is a compression joint? These pipes are usually made of copper, which can easily develop small scratches and burrs. To avoid this problem, it is recommended to use a wire wool pad around your copper pipe. You can get wire wool from most builders’ merchants. Another tip to keep your plumbing safe is to use PTFE tape around compression fitting threads. This tape will seal over-large gaps within the union of threads. A compression joint is an easy-to-install plumbing connection. Even those with limited plumbing knowledge can easily install it. However, there are a few things you should remember when installing this type of plumbing connection. In order to avoid any possible leaks, you should also avoid wriggling the pipe when connecting it to the compression fitting. You should only do this if the pipe runs under a sink or to an out-of-the-way fixture. A compression joint is a three-piece assembly that’s used to connect thin-walled pipes and tubes. The olive and nut fit together in a way that prevents leakage. Compression joints can be used for a variety of purposes, including connecting two thin-walled pipes or tubes. You can find compression joints at home improvement centers, plumbing supply stores, and even at the local hardware store. To install a compression joint, you’ll need to remove the previous nut. This will expose the pipe and allow you to deburr the pipe end. Next, you’ll need to tighten the nut with a compression wrench. Then, insert the ferrule into the pipe, which will seal the joint. You can then check the joint for leaks by tightening it to a quarter turn. Once you’ve unclipped the ferrule, you can now remove the ferrule. It should be easy to remove with a wrench, but you can also use a hacksaw to cut through the ferrule and pipe. Be sure to cut off the ferrule before you try to remove the compression joint, or you could end up with a leaky fitting. If you’re lucky, it will come right off the end of the pipe. If not, you might have to cut it off and install it on your own. A compression fitting is similar to a snap-on necktie – it fits together quickly and easily. This type of fitting is often used for low-pressure applications, and the pressure can range anywhere from -5 psi to 125 psi. Another benefit of compression fittings is that they can easily be disassembled for cleaning and replacement. Additionally, they are easy to repair if they suffer from corrosion. Moreover, compression fittings don’t require any other sealant material, as they seal through the threads alone. Click here to learn more about derby plumbers.